View all Lexium 05 & Motors
motion servo drive LXM05B - 2.5 kW - 200..240 V - 1-phase - with EMC filterShow more characteristics
LXM05BD28M2 has not been replaced. Please contact your customer care center for more information.
Add to My Products Remove from My Products
The maximum number of products that can be compared is 4
Main range of productLexium 05 product or component typeMotion servo drive component nameLXM05B network number of phasesSingle phase power supply voltage200...240 V - 15...10 % continuous output current13 A at 8 kHz15 A at 4 kHz nominal power2.5 kW at 4 kHz discrete input number2 safety discrete input(s)4 logic discrete input(s) type of polarizationNo polarization impedances for Modbus Complementary power supply voltage limits170…264 V supply frequency50/60 Hz - 5...5 % power supply frequency limits47.5…63 Hz transient RMS output current20 A at 4 kHz for 3 s20 A at 8 kHz for 3 s line current23 A at 200 V19.2 A at 240 V maximum prospective line Isc1 kA switching frequency8 kHz4 kHz overvoltage categoryIII inrush current60 A maximum leakage current30 mA output voltage<= power supply voltage insulationElectrical between power and control recommended type of cable for mounting in an enclosureSingle-strand IEC cable (temperature: 45 °C) copper 70 °C PVCSingle-strand IEC cable (temperature: 45 °C) copper 90 °C XLPE/EPR electrical connectionTerminal, clamping capacity: 6 mm², AWG 10 (PA/+, PBI, PBe)Terminal, clamping capacity: 6 mm², AWG 10 (R/L1, S/L2, T/L3) tightening torquePA/+, PBI, PBe: 1.2 N.mR/L1, S/L2, T/L3: 1.2 N.m discrete input typeLogic (LI1, LI2, LI3, LI4 terminals)Safety (PWRR_A, PWRR_B terminals) sampling durationANA1+/ANA1-, ANA2+/ANA2-: 0.25 ms analogLI1, LI2, LI3, LI4: 0.25 ms discrete discrete input voltage24 V DC for logic24 V DC for safety discrete input logicNegative (LI1, LI2, LI3, LI4) at State 0: > 19 V at State 1: < 9 V conforming to EN/IEC 61131-2 type 1Positive logic (compliment of PWRR_A, compliment of PWRR_B) at State 0: < 5 V at State 1: > 15 V conforming to EN/IEC 61131-2 type 1Positive logic (LI1, LI2, LI3, LI4) at State 0: < 5 V at State 1: > 15 V conforming to EN/IEC 61131-2 type 1 response time<= 10 ms discrete output number2 discrete output typeLogic output(s) (LO1, LO2)24 V DC discrete output voltage<= 30 V DC discrete output logicNegative (LO1, LO2) conforming to EN/IEC 61131-2Positive (LO1, LO2) conforming to EN/IEC 61131-2 contact bounce time1 ms for LI1...LI4 braking current50 mA response time on output1 ms (LO1, LO2) for discrete output(s) absolute accuracy error< +/- 1 % 25 °C< +/- 2 % over operating temperature range linearity error< +/- 0.5 % analogue input typeANA1+/ANA1-, ANA2+/ANA2- analog input: differential +/- 10 V, impedance: >= 10000 Ohm, resolution: 14 bits protection typeInputs signal: against reverse polarityOutputs signal: against short-circuits safety functionPWR protection of the machine stop and/or prevent unintended operation of the servo motor conforming to IEC/EN 61800-5-2PWR protection of the machine stop and/or prevent unintended operation of the servo motor conforming to ISO 13849-1 level dPWR protection of the system process stop and/or prevent unintended operation of the servo motor conforming to EN/IEC 61508 level SIL2PWR protection of the system process stop and/or prevent unintended operation of the servo motor conforming to IEC/EN 61800-5-2 communication port protocolModbusProfibus DP connector typeRJ45 (labelled CN4) for ModbusSpring terminals (labelled CN1) for Profibus DP physical interface2-wire RS485 multidrop Modbus2-wire RS485 multidrop Profibus DPRS422 for 1 A/B input(s), <= 400 kHzRS422 for 1 ESIM output input(s), <= 400 kHzRS422 for 1 P/D input(s), <= 400 kHz transmission rate9600 bps, 19.2, 45.45, 93.75, 187.5, 500 kbps, 1.5, 3, 6, 12 Mbps for Profibus DP9600, 19200, 38400 bps for Modbus data format8 bits, no parity, 1 or 2 stop for Modbus8 bits, odd or even parity, 1 stop for Modbus number of addresses1…126 for Profibus DP1…247 for Modbus communication service12 Process Data bytes for Profibus DP8 PKW bytes for Profibus DPCommunication monitoring for ModbusCommunication monitoring for Profibus DPDiagnostics (08) for ModbusPPO type 2 for Profibus DPRead device identification (43) for ModbusRead holding registers (03) for ModbusRead/write multiple registers (23) for ModbusWrite multiple registers (16) for ModbusWrite single register (06) for Modbus diagnosticsDrive voltage: 1 LED (red)ERR: 1 LED (Profibus DP)RUN: 1 LED (Profibus DP) signalling functionDisplay of faults integrated 7-segment display terminal max nodes number31 for Modbus input resistance5 kOhm markingCE type of coolingNatural convection operating positionVertical +/- 10 degree net weight2 kg Environment EMC filterIntegrated electromagnetic compatibility1.2/50 µs - 8/20 µs surge immunity test level 3 conforming to IEC 61000-4-5Electrical fast transient/burst immunity test level 4 conforming to IEC 61000-4-4Electrostatic discharge immunity test level 3 conforming to IEC 61000-4-2Radiated radio-frequency electromagnetic field immunity test level 3 conforming to IEC 61000-4-3 standardsEN/IEC 61800-5-1EN/IEC 61800-3EN/IEC 50178 product certificationsCULUL IP degree of protectionIP20 on upper part with protective cover removed conforming to EN/IEC 60529IP20 on upper part with protective cover removed conforming to EN/IEC 61800-5-1IP41 on upper part with protective cover in place conforming to EN/IEC 60529IP41 on upper part with protective cover in place conforming to EN/IEC 61800-5-1 vibration resistance1 gn (f= 13…150 Hz) conforming to EN/IEC 60068-2-61.5 mm peak to peak (f= 3…13 Hz) conforming to EN/IEC 60068-2-6 shock resistance15 gn for 11 ms conforming to EN/IEC 60028-2-27 pollution degree2 conforming to EN/IEC 61800-5-1 environmental characteristicClasses 3C1 conforming to IEC 60721-3-3 relative humidityClass 3K3 (5 to 93 %) without condensation conforming to IEC 60721-3-3 ambient air temperature for operation0…50 °C ambient air temperature for storage-25…70 °C operating altitude<= 1000 m without> 1000...2000 m with conditions Contractual warranty Warranty18 months
Technical FAQsNo results found.Unfortunately, related FAQs are unavailable due to temporary technical issues. Please try again later.