Browse FAQs

In Vijeo Designer, why doesn't it allow me to configure %I addresses like %I100?

Published date: 18 April 2019

Issue:
In Vijeo Designer, why doesn't it allow me to configure %I addresses like %I100?

Product Line:
Vijeo Designer (all versions)

Resolution:
In Vijeo Designer, the proper format for a %I address is %Ix.y.z where x=rack number, y=module number, and z=channel number.

This information is typically obtained from your PLC application and it must correspond accordingly to properly communicate.

Was this helpful?

What can we do to improve the information ?

Can't find what you are looking for?

Reach out to our customer care team to receive information on technical support, assistance for complaints and more.